Garage doors are heavy and complicated due to their many working parts. The wires take the energy from the springs to raise the door and halt its drop. A cable can extend too far, come unbuckled, slide off a pulley, snap, or develop wear and tear. Knowing how to fix a garage door cable is useful in such a situation. How to reattach and replace garage door cables differ depending on whether the cable system is torsion or extension spring. It’s recommended to contact a garage door spring repair provider to take care of it.

Take a look at the cable:

Lift cables are a potential source of injury or damage, so it’s important to check them often. Replace frayed or corroded cables before they break. Unwinding from drum rollers or slipping off pulleys is more likely to occur with cables that sag or look loose when the door is fully open. The sag may be the result of a loose clamp or lengthened cables. Adjust the cable tension if this happens.

Lock the gate:

The location of the door at the time the cable breaks or releases will determine this next step. Put a g-clamp on the track as close as possible, but not under the bottom wheel, whether the door is open or just a crack. The door will be unable to close if you do this. Clamps aren’t necessary if the door is completely closed and the cable snaps, jumps a pulley, or comes loose.

Release the lock:

To replace or reattach broken garage door cables, the door must be open to remove tension on the torsion or extension springs. Raise the door until it is completely open, and then secure it in that position. Lifting a heavy door may take two or three persons; therefore, it’s always best to leave it at a safe height to avoid any potential injuries.

Ensure the springs are in working order:

When a cable snaps, it can send a wave of destructive force into a spring, whether an extension or torsion. Check the springs for damage; if you find any, replace them. When a torsion spring slips, it can cause the broken garage door cables to become loose, requiring rewinding and tightening.

Don’t wait around:

Both lift cables should be replaced simultaneously if one has to be due to fraying, rust, or breaking. When replacing the wires, swapping out the bottom mounting bracket is also a good idea. If your door has an extension spring, inspect the cable’s connection to the door’s upper frame for signs of wear and replace it if necessary.

Conclusion:

You may need more confidence in fixing a broken garage door cable. Don’t stress if you don’t know how to fix a garage door spring cable or don’t have the time to deal with a heavy, stuck garage door blocking your car. Also, it may be time to replace your garage door springs if you’ve noticed a decline in the door’s smooth operation or the appearance of any unusual sounds. Garage door spring repair technicians are well-versed in fixing broken garage door lift cables and springs and have extensive experience.